Prepare
Fill the spray bottle with purified water
Peel
Wet the tweezers and remove the film
Mist
Spray water on the film, then place it on the watch
Place
Use the tweezers to gently fit and adjust
Ready to Wear
Do not wear the watch for 24 hours until fully dry
Spare Film Included
Use it for any replacement
Before
Precision-fit protective film designed to preserve your timepiece in NOS condition.
About 2 hours, distilled water, a microfiber cloth, alcohol wipes (included), plastic tweezers (included), and a clean desk.
No. For best adhesion, please use distilled water only.
Gently wipe away oil and dust with the included microfiber cloth.
Playing
Yes. Installation is simple with plastic tweezers and a light water mist.
Place a desk lamp nearby and shine light across the film sheet for better visibility.
Clasp → Case → Bracelet → Bezel → Glass
If needed, trim the required section with scissors and proceed carefully.
After
Gently push them out with your fingers or tweezers. Micro-bubbles usually disappear within 72 hours.
For bezel film, remove the inner circle first.
For glass film, add one drop of mild dish soap to the spray water.
Support
The film is removable, and spare pieces are included.