1. Prepare
Clean the area with plastic tweezers and distilled water.
Use pharmacy-grade distilled water.
2. Peel
Lift gently from the margin to remove the part.
Use the film edge to brush away dust.
3. Mist
Lightly mist distilled water on the adhesive side.
Add three drops of dish soap for glass pieces.
4. Place
Slide the film into position on the specific part.
Handle your timepiece softly.
5. Ready to Wear
Fully set after 24 hours.
Use the included spare film for any replacement.
Savor your timepieces
Preserving NOS — every day.
Founder’s Note: You may add another watch. We’ll be here. ✋
Before You Start
Precision-fit protective film designed to preserve your timepiece in NOS condition.
About 2 hours, distilled water, a microfiber cloth, alcohol wipes (included), plastic tweezers (included), and a clean desk.
No. For best adhesion, please use distilled water only.
Gently wipe away oil and dust with the included microfiber cloth.
During Application
Yes. Installation is simple with plastic tweezers and a light water mist.
Place a desk lamp nearby and shine light across the film sheet for better visibility.
Clasp → Case → Bracelet → Bezel → Glass
If needed, trim the required section with scissors and proceed carefully.
After Application
Gently push them out with your fingers or tweezers. Micro-bubbles usually disappear within 72 hours.
For bezel film, remove the inner circle first.
For glass film, add one drop of mild dish soap to the spray water.
Peace of Mind
Take your time. Adjust if needed.
The film is removable, and spare pieces are included.